top of page

Mechanical Movement 19 — Three-Cord Pulley System

4 hours ago
2 min read
Mechanical Movement 19 — Three-Cord Pulley System
Mechanical Movement 19 — Three-Cord Pulley System

How can three pulleys give twenty-six to one?

Mechanism No. 19 from 507 Mechanical Movements, one of four pulley arrangements (Nos. 19–22). Three cords, each tied to the axle of its own pulley: each cord runs down under a small pulley fixed to the load, back up over its pulley and on to hold the next pulley in the chain. The upper pulley is fixed. Each pulley in the chain is pulled down by three parts of its cord, so each cord carries three times the tension of the next, and every cord lifts the load twice. With your pull F: 2F + 6F + 18F = 26F.


How it works, step by step

1. Three cords

Each cord is tied to its own pulley’s axle, loops under a pulley on the load and holds the next pulley.

2. Each pulley triples

Your pull 59 N (ideal): the last pulley is pulled down by three parts of its cord, so cord 2 carries 3×, cord 1 carries 9×.

3. Twenty-six shares

The load gets 2 × (1 + 3 + 9) = 26 shares: pull 76 N for 1472 N.

4. Barely moving

The load has risen only 14.8 cm while 370 cm of cord passed your hand.

The key idea

F ≈ W / 26 — Each cord triples the pull and lifts the load twice: 2 + 6 + 18 = 26 shares.

Three pulleys, each tripling the pull and lifting the load twice, give 26 : 1, at the price of 26 times the rope.

Model and assumptions

Mechanical advantage taken from the geometry: 26 (= 3³ − 1). Brown’s general rule for Nos. 19–22 (“2 multiplied by itself as many times as there are movable pulleys”) applies to cords fixed to a stationary point; here the cords are tied to the moving pulleys themselves, which gives more. As the load rises 1 cm the two lower pulleys drop 2 cm and 8 cm. Friction: lifting needs about W / (26 η⁶).

Frequently asked questions

How can three pulleys give 26?

Each cord triples the pull it receives and also lifts the load twice: 2 + 6 + 18 = 26.

Does Brown’s 2ⁿ rule apply?

Not here: the rule is for cords fixed to a stationary point; tying them to the moving pulleys gives more.

What is the drawback?

26 times as much cord for each centimetre of lift.

Part of the 507 Mechanical Movements series

This is Movement No. 19 from Henry T. Brown’s 507 Mechanical Movements (1868), redrawn and simulated by BCRUZ.

Comments


bottom of page