top of page

Mechanical Movement 20 — Three-Pulley Chain

4 hours ago
2 min read


Mechanical Movement 20 — Three-Pulley Chain
Mechanical Movement 20 — Three-Pulley Chain

How do three pulleys give seven to one?

Mechanism No. 20 from 507 Mechanical Movements, one of four pulley arrangements (Nos. 19–22). The top pulley is fixed; the two below it hang one from the other. Three cords each run from the load up over a pulley, and their other ends hold the next pulley down the chain; the last cord comes to your hand. Each pulley is pulled down by both parts of its cord, so each cord carries twice the tension of the one below it. The load hangs on 1 + 2 + 4 = 7 times your pull.


How it works, step by step

1. Three cords to the load

Each cord runs from the load up over a pulley and holds the next pulley; the top pulley is fixed.

2. Doubling down the chain

The last pulley is pulled down by both parts of its cord, so the cord holding it carries twice as much. Ideal pull 101 N.

3. Seven shares

The load hangs on 1 + 2 + 4 = 7 times your pull: 115 N for 687 N.

4. Seven times the rope

80 cm of cord for 11.9 cm of lift.

The key idea

F ≈ W / 7 — Each pulley doubles the pull and every cord ends on the load: 1 + 2 + 4 = 7 shares.

Each pulley doubles the pull and every cord also lifts the load: 1 + 2 + 4 = 7 with three pulleys.

Model and assumptions

Mechanical advantage taken from the geometry: 7 (= 2³ − 1). Brown’s general rule for Nos. 19–22 gives 2ⁿ for cords tied to a fixed point; here the cords are tied to the load, which adds the shares 1 + 2 + 4. As the load rises 1 cm the second pulley drops 1 cm and the third 3 cm. Friction: lifting needs about W / (7 η³).

Frequently asked questions

Why 7 and not 8?

The cords end on the load, so the shares 1, 2 and 4 add up to 7; with cords fixed to the ceiling it would be 2³ = 8 (Movement 22).

How do the pulleys move?

The second drops as fast as the load rises, the third three times as fast.

Is the top pulley movable?

No, it is fixed; the other two move.

Part of the 507 Mechanical Movements series

This is Movement No. 20 from Henry T. Brown’s 507 Mechanical Movements (1868), redrawn and simulated by BCRUZ.

Comments


bottom of page