Mechanical Movement 23 — Weighted Belt Tensioner

How does a hanging weight keep a belt tight on a moving pulley?
Mechanism No. 23 from 507 Mechanical Movements: “A contrivance for transmitting rotary motion to a movable pulley.” The pulley at the bottom moves up and down; on its own, the belt would go slack or be stretched tight. “In order to keep a uniform tension on the belt, a pulley, A, carried in a frame sliding between guides (not shown), hangs from a rope passing over the two guide-pulleys, B, B, and is acted upon by the balance weight, C.” As the lower pulley rises, A is lifted by the weight and takes up the extra belt; as it falls, the belt pulls A down and the weight rises.
How it works, step by step
1. A pulley that moves
The lower pulley is moved up and down while it is being driven. Alone, the belt would go slack or overstretch.
2. Pulley A takes up the belt
A rides on the belt in a sliding frame, hung from a rope over B, B to the weight C.
3. The weight sets the tension
Belt tension T = W / (sin α₁ + sin α₂): 215 N now. With a fixed idler it would be 215 N.
4. It follows the motion
Lower pulley up 42 mm, so A rises 54 mm and the belt length stays the same.
The key idea
T = W / (sin α₁ + sin α₂) — The hanging weight sets the belt tension; pulley A rises or falls to take up or give out belt.
A weighted tension pulley moves to take up or give out belt, so the tension stays almost constant.
Model and assumptions
Belt geometry is solved exactly: for each position of the moving pulley, pulley A settles where the belt length is unchanged. Tension from the weight: T = W / (sin α₁ + sin α₂), where α₁, α₂ are the angles of the two belt runs at A. For comparison, a fixed idler would change the tension by EA · ΔL / L (EA = 8 kN); below zero the belt is slack.
Frequently asked questions
Why not use a fixed idler?
When the driven pulley moves, a fixed idler would let the belt go slack or overstretch it.
What sets the belt tension?
The weight: T = W / (sin α₁ + sin α₂), from the angles of the belt runs at the tension pulley.
Where is this used today?
Spring or weight tensioners on engine belts, conveyors and machines with moving pulleys.
Part of the 507 Mechanical Movements series
This is Movement No. 23 from Henry T. Brown’s 507 Mechanical Movements (1868), redrawn and simulated by BCRUZ. ← Mechanical Movement 22 — Three Movable Pulleys · Mechanical Movement 24 — Spur Gears →




Comments