Mechanical Movement 25 — Bevel Gears

How do bevel gears turn a drive through a right angle?
Mechanism No. 25 from 507 Mechanical Movements: bevel gears. Their teeth are cut on cones whose tips meet at the point where the two shafts cross, so the pitch cones roll on each other without slipping, like two spur gears bent round a corner. The speed ratio is still the ratio of the numbers of teeth. When the two wheels are equal, the cones are at 45° and the pair is called “miter gears”, turning the drive through 90° at the same speed.
How it works, step by step
1. Teeth on cones
Each wheel’s teeth are cut on a cone; the tips of both cones meet where the two shafts cross.
2. Rolling cones
The pitch cones (45° and 45°) roll on each other like spur gears bent round a corner.
3. Speed ratio
Driver 30.0 rpm, driven 30.0 rpm: n₂ = n₁ × 24 / 24.
4. Miter gears
With equal wheels both cones are at 45°: the drive turns 90° at the same speed. These are called miter gears.
The key idea
n₂ = n₁ · z₁ / z₂ — Teeth on cones that share one tip roll like spur gears; equal wheels at 45° are miter gears.
Cutting the teeth on cones that share one tip lets two shafts at right angles mesh and roll together.
Model and assumptions
Pitch-cone angles: tan δ₁ = z₁ / z₂ and δ₁ + δ₂ = 90°. Speed ratio n₂ / n₁ = z₁ / z₂. Set the driven wheel to 24 teeth for a miter pair (δ = 45°, ratio 1 : 1).
Frequently asked questions
What are miter gears?
A pair of equal bevel gears at 45°, turning the drive 90° at the same speed.
Why are bevel teeth on cones?
So both pitch cones share one tip at the point where the shafts cross and can roll together.
How is the ratio found?
As for spur gears: n₂ = n₁ × z₁ / z₂.
Part of the 507 Mechanical Movements series
This is Movement No. 25 from Henry T. Brown’s 507 Mechanical Movements (1868), redrawn and simulated by BCRUZ. ← Mechanical Movement 24 — Spur Gears · Mechanical Movement 26 — Crown Wheel →




Comments