Bend relief: Formula, Calculator and Worked Example

A bend relief is a small cut at the edge of the sheet, beside the bend line, that keeps the material from tearing and the adjacent edge from distorting. Rule of thumb: width ≥ thickness and depth ≥ inside radius + thickness.
When a flange is bent from only part of an edge, the material at the end of the bend line has nowhere to go. Without a relief cut the sheet tears, bulges or leaves an ugly corner that fails inspection. A small, correctly sized notch lets the bend form cleanly and keeps the adjacent edge flat.
Where bend relief matters
Bend reliefs appear on almost every formed enclosure, bracket and chassis: tabs bent up from a larger panel, partial flanges, hems that stop short of a corner and any bend that meets an inside cut-out.
In sheet metal design, small geometric decisions such as radii, reliefs and hole positions decide whether a part can be cut and bent reliably on standard press brakes, and they have a direct effect on cost, flatness and repeatability.
Formula
width ≥ max(t, 1 mm) • depth ≥ R + t
The calculation uses the following inputs:
Sheet thickness [mm], accepted range 0.3 to 12 mm
Inside bend radius [mm], accepted range 0.2 to 30 mm
Proposed relief width [mm], accepted range 0.2 to 30 mm
Proposed relief depth [mm], accepted range 0.2 to 60 mm
It returns:
Status
Minimum recommended width [mm]
Minimum recommended depth [mm]
Assumptions: DFM rule of thumb for formed sheet parts. Larger reliefs reduce cracking risk in less ductile materials.
Worked example
Take the following values, which are also the default settings of the calculator:
Sheet thickness: 2 mm
Inside bend radius: 2 mm
Proposed relief width: 2 mm
Proposed relief depth: 5 mm
Applying the formula gives:
Status: Meets the rule of thumb
Minimum recommended width: 2 mm
Minimum recommended depth: 4 mm
With these values no design warning is triggered, so the result sits inside the usual practical limits. Change one input at a time in the calculator to see how sensitive the result is; the response curve shows how the main result varies across the full range of the first input.
How to use the calculator
Choose metric or US customary units with the toggle at the top. Inputs and results convert automatically.
Enter sheet thickness, inside bend radius, proposed relief width and the remaining inputs with the sliders or by typing values.
Read the main result, status, together with the secondary results and any warning shown below it.
Check the schematic: it redraws with your values so you can confirm the geometry and dimensions make sense.
Design tips
Make the relief at least as wide as the sheet thickness, and never narrower than about 1 mm, so the punch or laser can produce it reliably.
Extend the relief past the bend line by at least the inside radius plus the thickness; a deeper relief costs nothing and removes tearing risk.
Use rounded (obround) reliefs on hard alloys such as 6061-T6 or stainless steel to avoid crack initiation at sharp corners.
Frequently asked questions
What happens if I omit the bend relief?
The bend pulls material from the unbent area, causing tearing, bulging or distortion at the end of the bend line, and the flange angle near the corner is often inaccurate.
Should the relief be rectangular or round-ended?
Rectangular reliefs are simplest to program and fine for mild steel and soft aluminum. Round-ended reliefs spread stress and are preferred on harder or less ductile materials.
Which units does the bend relief calculator use?
Inputs are entered in mm in metric mode. Switching to US customary units converts lengths to inches, forces to pound-force, stresses to psi and masses to pounds where applicable, and all results are converted the same way.
The formulas and reference values on this page are intended for education and preliminary design. Always verify critical parts against the applicable standards, supplier data and, where required, a qualified engineer.




Comments