top of page

Mechanical Movement 26 — Crown Wheel

7 hours ago
2 min read
Mechanical Movement 26 — Crown Wheel
Mechanical Movement 26 — Crown Wheel

How does a crown wheel turn a drive through a right angle?

Mechanism No. 26 from 507 Mechanical Movements: “The wheel to the right is termed a crown-wheel; that gearing with it is a spur-gear.” The crown wheel carries its teeth on its face, pointing sideways, so an ordinary spur pinion on a shaft at right angles can mesh with them. The book adds that these wheels “are not much used, and are only available for light work, as the teeth of the crown-wheel must necessarily be thin.” The reason: the spacing of the face teeth grows with the radius, while the spur teeth are parallel, so they fit properly only along a narrow band.


How it works, step by step

1. Teeth on the face

The crown wheel’s teeth point sideways from its face, so a plain spur pinion at right angles can mesh with them.

2. Turning the corner

Pinion 40.0 rpm about a vertical shaft; crown 20.0 rpm about a horizontal one.

3. Ratio of the teeth

As with any gears, n₂ = n₁ × 24 / 48: the 48-tooth crown turns at half the speed.

4. Why so thin

Face-tooth spacing grows with radius, but the pinion’s teeth are parallel: they fit along a narrow band only.

The key idea

n₂ = n₁ · z₁ / z₂ — Teeth on the face let a spur pinion drive at right angles, but they fit along a narrow band only: light work.

Face teeth let a spur pinion drive round a right angle, but they must be thin, so crown wheels suit light work only.

Model and assumptions

Speed ratio n₂ / n₁ = z₁ / z₂ = 24 / 48. Crown tooth spacing is proportional to radius (2πr / z₂), so a parallel spur tooth fits at one radius only; the usable face width, and so the load, stays small.

Frequently asked questions

What is a crown wheel?

A gear with teeth on its face rather than its rim, so a plain spur pinion can mesh at 90°.

Why is it only for light work?

The face-tooth spacing grows with radius but the pinion teeth are parallel, so they fit along a narrow band only.

Where were crown wheels used?

Clocks and light mechanisms; modern face gears use specially shaped teeth.

Part of the 507 Mechanical Movements series

This is Movement No. 26 from Henry T. Brown’s 507 Mechanical Movements (1868), redrawn and simulated by BCRUZ.

Comments


bottom of page